One very common way of tracking tools that I have now seen at several companies is a spreadsheet, or equivalent chat/channel, where when you borrow a piece of equipment, you are meant to update the tracking spreadsheet.

The problem with this is that this is easiest to do on your desktop, but when you sit down at your desktop your mind goes to using the tool you borrowed, and forget to update. Or you are borrowing it to go to somewhere else, so you can’t update it until you come back, again leaving a lot of scope for forgetting.

Having access to a laser cutter can be very useful – while I was at the computer lab I had access to one and used it to make a keyboard suited for my fingers.

Conclusion: the natural resting position for fingers didn’t take into account the differences in reach/the awkwardness of pinky bottom/ring finger top row, especially since on my right hand the pinky and ring fingers are connected.

The firmware is available on my fork of qmk_firmware, branch kovirobi-steno-updated.

I had the fortune of snagging a cheap Stentura 200 SRT from eBay. I did end up using it for a while, even wrote my CompSci bachelors dissertation (both the software and the write-up) using it.

Later, I modified it to make it look more steam punk: put leather imitation key covers, repainted it; and I also replaced the internals with a Raspberry Pi (model 3B I think) to make it be more like a laptop and not require a serial port.

For my undergraduate degree I wrote a Scheme to Java byte-code compiler, which was pretty fun. The dissertation is available on GitHub and the compiler is in the same repo

It wasn’t terribly fast, but it did work, including first-class continuations (probably the biggest reason for the slowness is the stack representation).